颈椎调整手法(国外英语资料).docVIP

颈椎调整手法(国外英语资料) Original address: cervical manipulation Author: medicine is kind cervical vertebra First, the distribution of the vertebral nerve and its symptoms: (Figure 6-1) /P, p Two. Characteristics of the cervical spine (1) the X negative mapping examination method for the head vertebra: 1. Draw an extension line along the back of the vertebral C2. 2. Draw an extension line along the back of the vertebral C7. 3, the two extension lines must be handed to one point, forming two pairs of vertex angles, the normal curve of the cervical spine, the angle of the vertex angle of 40 degrees. If it is greater than 40 degrees, the curve of the cervical spine is too curved (extension). If less than 40 degrees, the curve of the cervical spine is too straight (straight) (two) the characteristics of the cervical spine structure (Figure 6-2) 1, the average person has 7 cervical vertebrae, 6 intervertebral plates, and 35 large and small joints. There is no intervertebral plate in the occipital (annulus) vertebra (C0-C1) and between the ring and axis (C1-C2). 2, the vertebral arch is shorter, so the intervertebral foramen is smaller. When the vertebral body is displaced, or when the ligamentum flavum or posterior longitudinal ligament becomes hypertrophy due to ossification, or when the intervertebral disc is prominent, the spinal cord or nerve root is compressed or stimulated. 3, the cervical vertebra vertebral artery each one; the left side is bigger, the right side is smaller. From the sixth cervical transverse foramen to enter through the cervical vertebral transverse foramen around ambient. Then turn to the front and cross the outer edge of the posterior occipital membrane into the skull through the foramen magnum. Therefore, the correction of the head of the vertebral column should be particularly careful, in order to avoid accidents, because the cervical vertebra vertebral artery in both sides of the cross hole, vulnerable to damage, therefore, must not be careless! 4, a