施工测量放样作业方法及要求(国外英文资料).docVIP

施工测量放样作业方法及要求(国外英文资料) The Yellow River holds the earth still, and the north wind and snow hate it. He that doeth evil shall die himself. The test of the stone shall be three days full, and the discernible shall stay for seven years. The teacher, therefore, the ministry of the ministry of the ministry of knowledge. Heaven and earth are in the dark. Construction survey lofting method and requirements of 22006-12 to 28 12:06 implement routine Settings: such as units, coordinate method, compensation mode, the types of prism, a prism constant, temperature, pressure, etc. 4. Use the total station with memory, can in advance to control points (including employs measurement sites, checkpoint) and lofting point coordinate data input device memory, and check. Four, the whole station coordinate method sets the station + the polar coordinate method puts a point Set up the whole station at the control point and complete the middle, and then check the Settings for the instrument: temperature, air pressure and prism constant. Input (enter) the 3d coordinates of the station, take and input the instrument high, input (adjust) the rear view coordinates, and then look after the sight. If there is a prism in the rear view point, the input prism is high enough to measure the coordinates and elevation of the view point immediately and check with the known data. Target another control point, check the azimuth or coordinates. At another known elevation point, a vertical prism or ruler examines the instruments high line of sight. When calculating the function of the instrument itself, the recorder should also carry out the correctness of the input data. Set up the rack and prism on the undetermined site, take, record and type the prism high, measure, record the coordinates and elevation of the fixed point. The above steps are to measure the site. Set up the station by step 1 on the site, and then check the coordinates and elevation of the other site. The recorder coordinates the distance a