机械试题(国外英文资料).docVIP

机械试题(国外英文资料) One. Fill in the blanks. (30 points, 1 minute.) The basic process of the crystallization of liquid metal is the nucleus and nucleus. Ferrite (F) is an interstitial solid solution formed by a carbon dissolved in alpha-fe, and its lattice type Is: body centred cubic. The hardness of the hardened steel is generally hardened by the rockwell (HRC) hardness. And the hardness of detecting annealing and positive steel is commonly used in the hardness of brinell (HRB). GCr15 steel is a rolling bearing steel whose Cr has a mass score of 1.5%. 5.16 Mn steel is alloy structural steel and its carbon is 0.16%. The meaning of 03 in qt600-03 is that the minimum extension is 3%. The dividing line between steel and cast iron is: 2.11%. The microstructure of the bainite is mainly in B and B, where the combined properties of B are good. The higher the quenching temperature of steel, the higher the carbon content in martensitic body after quenching, the martensite crystal The larger the grain, the more the residual austenite. When steel is heated, the formation of A is formed by the formation of A crystal nucleus, A nucleus of A nucleus, which is grown on both sides of F and Fe3C. The dissolving of the residual Fe3C and the homogenization of A are made up of four basic processes. Normal surface hardening should be made of carbon steel, which should be selected with carbon steel. The hardened medium used by carbon steel is water, and alloy steel is oil. 14. T10 steel (Ac1 material 727 ℃, Accm material 800 ℃) annealing sample after 700 ℃, 780 ℃, 860 ℃ heat insulation, and organization in the water cooling are: P + Fe3C, Fe3C + M + Ar, M + Ar. The carburizing steel is slowly cooling after carburizing, and the distribution of the surface centripetal is: P + Fe3C Ⅱ (mesh), P, P + F. score Two. Determine (10 points, 1 minute for each question) one 2 3 4 5 6 7 8 9 10 x Square root Square root x x x Square root Square root x x In other conditions, sand casting is thinner than metal