海尔XQG50-D808滚筒洗衣机常见故障分析及排除方法(国外英文资料).docVIP

海尔XQG50-D808滚筒洗衣机常见故障分析及排除方法(国外英文资料) Haier xqg50-d808 cylinder washing machine common failure analysis and elimination method [date: 2009-11-14] source: [font: large medium small] (1) the washing machine does not start the cause analysis: Whether the socket meets the requirements or not, the connection is good. The machine door is closed, the micro-delay switch contacts are good. Bad electrical contact or motor damage. 4, click the start button (start/pause button to start the rear light), and there is a beeping prompt. The faucet is open. Test method: Check the power plug and socket to make it contact well. Check if the micro-delay switch is good, if good is the contact problem, it should be clamped. Clamp the motor or replace the motor. Repress the start/pause button. Turn on the faucet and restart the program. (2) analysis of the reasons for the non-water use of the washing machine: Incorrect operation or low water pressure (below 0.05 Mpa). The machine door is closed, the micro-delay switch contacts are good. 3, the water inlet solenoid valve failure. Water level switch failure. Test method: 1, review: (l) the faucet is open (2) the pipe is bent and blocked (3) the electromagnetic valve is blocked (4) the program indicates whether the location is accurate (5) the water pressure is too low 2, check the door hook and door lock contact whether good, bad adjustment; Check if the micro-delay switch is good. Check whether the solenoid valve is good and retighten. The mouth blows water level switch, should click sound, if not change. (3) analysis of the causes of washing machine and not drainage: Improper operation. Drainage pump failure or plugging. The water level in the washing machine is too high to be exhausted within the stipulated time Test method: 1, review: (l) the drain pipe is bent and the filter is cleaned (2) the drainpipe height is between 80 and 100 cm (3) verify that the procedure is accurate (4) resetting the drainage procedure Connect the power source