炉子安装(国外英文资料).docVIP

炉子安装(国外英文资料) Further confirmation of the location of the installation; Open the box, remove the heating furnace, confirm the temperament is consistent, if not the agreement should be changed or do the record; Remove stents and drawings; Install flue: Connect the bottom five pipes, and be careful to add the gaskets and tighten them. Turn on the power and indoor temperature controller. Turn on the front panel of the machine, connect the power supply according to N, L, and E, according to the temperature controller to connect 1-3 contact, install the panel. 7. Water injection and leak detection: open the tap water inlet switch, switch on water injection, water injection to heating system, until 3 bar, close the switch, water injection to see whether there are funnelled, and pay attention to whether the relief valve pressure relief; Open the hot water tap at the same time to see if there are any leaks; Try the soap water to try to see if there is a gas leak in the gas line. Turn off the tap water, turn on the waterflood switch, turn on the faucet, and put a portion of the heating system in the water until the water pressure drops to about 1Bar. Fill in the installation record. This completes the installation process. This section describes the debugging process 1. To the system with water, open the exhaust valve on the radiator and water pump on the automatic exhaust valve, until the water pressure 1 bar, check to see if all piping connections has funnelled; Turn on the faucet to see if all the piping connections have a leak. Plug in the power socket and turn on the gas switch. Open the front panel; The first ignition, To turn the pattern into summer, turn on the faucet and observe the electronic fire and ignition. Adjust the water flow, adjust the temperature control of the hot water, and observe whether the flame has changed and changed. When the temperature is high, the flame is large and the flame becomes smaller. Turn the pattern to winter and watch the electronic