用万用表定性揣摸场效应管、三极管的短长(国外英文资料).docVIP

用万用表定性判断场效应管、三极管的好坏(国外英文资料) Use multimeter to determine the good and bad of the triode. Use multimeter to determine the quality of the tube and the triode The quality of the MOS field effect tube Use multimeter R x 10 k first Ω block (with 9 v and 15 v battery), take negative pens and (black) grid (G), are pens and pick the source (S) (red). To charge the grid and the source, there is a slight deflection of the meter pointer. Use multimeter R x 1 Ω blocked again, will take pens and drain (D), is the pen to the source (S), if a multimeter indicated value to a few ohms, explain field-effect tube is good. Two, qualitative judgment the electrode of the junction type field effect tube Set the multimeter to the R x 100, the red pen will pick one of the foot tubes, and the black marker will pick up the third leg. If the watch needle wobbles slightly, the third foot is the grid. To obtain more obvious observation effect, still can use the human body the dangling feet near or with his finger, as long as see the clock for large deflection, which is given to illustrate the grid dangling feet, the other two feet are source and drain. Judgment reason: the input resistance is greater than 100 m Ω jfets, and transconductance is very high, when the grid space electromagnetic field can easily when open the induction voltage signal in the grid, lead to the globe, pipe or tending to conduction. If the human induced voltage is added directly to the grid, the phenomenon is more pronounced because the input interference signal is stronger. A large deflection of the needle to the left means that the pipe tends towards the end of the pipe, and the leakage of the RDS increases, and the leakage of the current decreases in IDS. On the other hand, the needle is sharply deflected to the right, indicating that the tube is guided by the guide, the RDS, and the IDS arrow. But the direction of the needle in which direction is deflected should be determined by the polarity of induction voltage (for