英制螺纹参考(国外英文资料).docVIP

英制螺纹参考(国外英文资料) Instance: 1/4-28 UNF - 1 b this is a marked 1/4 inch thread is 28 refers to every inch thread nominal diameter 28 teeth, the tooth pitch of 1/28 of an inch, 25.4 mm / 28. The UN is the standard tooth of the thread, and the top corner is 60 degrees. A kind of thread standard, according to the shape of the cylinder and cone, According to the tooth type Angle of 55 °, 60 ° two kinds. 1/4, 1/2, 1/8 mark is the diameter of the thread, in inches. One inch is equal to eight, one quarter is two, and so on. Codename, name and standard number of commonly used British threads: B.S.W. standard whiter teeth series, general purpose cylinder thread B.S.F. standard whiter teeth series, general purpose cylinder threads Whit. S additional wyeth optional series, general-purpose cylinder threads Non-standard threads for Whit whiter teeth More than for the British standard BS84 tooth type Angle is 55 ° inch thread The uniform thread of the UN constant pitch series UNC coarse thread series The unified thread of the UNF fine tooth series UNEF superfine tooth series uniform thread UNS special series of unified threads The uniform thread of the UNR circular tooth base constant pitch The UNRC circular tooth base coarse teeth series uniform thread The UNRF circular tooth base teeth series uniform thread UNREF circular tooth base super fine tooth series uniform thread UNRS special series of thread on the base of the tooth More than for the American standard ANSIB1.1 tooth type (tooth bottom is flat or round) at the end of the internal and external thread of arc tooth UNR, UNRC, UNRF, UNREF, NRS is used only for male rather than female NPT (NPT) The NPSC connector USES direct pipe threads The NPTR guide is connected to the taper pipe thread NPSM mechanical connection with straight pipe thread NPSL lock nuts with straight pipe threads NPSH hose connection with straight pipe thread More than for the American standard ANSIB1.20.1 tooth type Angle 60 ° inch pipe thread NPTF dry seal