默纳克故障代码(国外英文资料).docVIP

默纳克故障代码(国外英文资料) The E01 inverter unit protects The cause of the problem Primary circuit output ground or short circuit; The tractor is too long; The workplace is overheated; The controller is loose inside the controller Processing method Exclude external problems such as wiring; An electric reactor or an output filter; Check if the air duct and fan are normal; Please contact the agent or manufacturer. E02 accelerated over current The cause of the problem Primary circuit output ground or short circuit; Whether the motor has been tuned to the parameters; The load is too heavy; The encoder is incorrect; It is normal for UPS to run the feedback signal E03 deceleration overcurrent The cause of the problem Primary circuit output ground or short circuit; Whether the motor has been tuned to the parameters; The load is too heavy; The deceleration curve is too steep; The encoder is not correct E04 constant speed over current The cause of the problem Primary circuit output ground or short circuit; Whether the motor has been tuned to the parameters; The load is too heavy; The rotating coder interferes with the big 02-04 processing method Check the output side of the frequency converter and run the contactor. Check to see if the power lines have surface damage and the possibility of a short circuit. Whether the connection is secure or not; Check to see if there is copper wire on the side of the motor. Check for short circuit or ground in the motor. Check whether the star contactor has caused the converter to be short-circuited. Check whether the motor parameter is in line with the nameplate; Redo the motor parameter learning; Check to see if the brake report is open before the failure. Check for mechanical card death; Check that the balance factor is correct; Check to see if the wiring is correct. The asynchronous motor can try to open the ring and compare the current to determine whether the coder is working properly. Check the encoder for each pulse count to be correct; Check