485是否用屏蔽线（国外英文资料）.doc

485是否用屏蔽线（国外英文资料） One, the concepts of the 485 bus: The communication distance of the 485 bus can reach 1200 meters. Based on the 485 bus structure theory, the 485 bus transmission distance can be up to 1, 200 meters under the precondition of the ideal environment. Its condition is communication wire rod quality standard, baud rate to 9600, only to load a 485 device, to make the communication distance of 1200 meters, so usually 485 bus, the stability of the actual distance of communication often amounted to less than 1200 meters. If the load equipment more than 485, wire impedance is not up to standard, wire diameter interloper, converter, poor quality, lightning protection equipment complex and baud rate increase will reduce the communication distance and so on factors. The 485 bus can communicate with 128 devices. In fact, not all 485 converter can take 128 devices, according to the model, and 485 of 485 converter chip device chip judging model, can only in accordance with the low chip to determine its load capacity. The average 485 chip load capability has three levels - 32, 128, and 256. Besides theoretical nominal often is actually unattainable, the longer the communication distance, the higher the baud rate, wire diameter, the thinner, the worse quality of wire rod, the worse, converter power supply converter quality (passive converter), the stronger the lightning protection, these will reduce the real load quantity. The 485 bus is the simplest, most stable, most mature industrial bus structure This concept is wrong. The 485 bus is an economical, traditional industrial bus that is used for the networking of devices. Its communication quality needs to be tested and tested according to the construction experience. The 485 bus is simple, but it must also be wired strictly according to the installation specifications. Second, the construction standards must be strictly followed In the construction of the 485 bus system, it must be strictly constructed according to