MP3、U盘故障＂无法识别的USB设备＂处理方法（国外英文资料）.doc

MP3、U盘故障＂无法识别的USB设备＂处理方法（国外英文资料） MP3, USB unrecognized USB device processing method Unrecognized USB device processing method The front-facing USB line is wrong. When motherboard USB line and the front USB interface corresponding to connect on the case take the positive and negative against this kind of failure occurs, it is also quite dangerous, because the positive and negative answer is likely to make USB device burned. So try to use the USB port in the back of the box, or use the extension cord. There is a shortage of USB ports. When the mobile hard disk is attached to the front USB port, there is a possibility that the system will fail to recognize the device. Because the mobile hard disk power is larger voltage is relatively strict, front interface may not provide enough voltage, inferior power, of course, also may be the cause of the problem. The solution is to dont answer the mobile hard disk on the front USB ports, replace the inferior low power of power or try to use an external hard disk box, if conditional word. Mainboard and system compatibility issues. The most famous of these failures is the compatibility of the NF2 motherboard and USB. If you are on the main board of NF2 encounter this problem, you can install the latest nForce2 special usb drive and patches, the latest motherboard patches and operating system patches, or if not try to refresh the motherboard BIOS are generally able to solve. System or BIOS problems. USB devices are not recognized in the system when you disable USB on the BIOS or operating system. The solution is to open the options associated with USB devices. Turn on the F2 or DEL keys, enter the BIOS, and select enable usb device. Be careful not to pull out when reading and writing, otherwise you may burn the chip. XP more USB devices in the task bar icon, open the icon will be displayed in the list U disk devices, choose to disable the device, and then you pull out the equipment, it will be safe. Judgment software hardware proble