MTK工程模式和测试模式指令（国外英文资料）.doc

MTK工程模式和测试模式指令（国外英文资料） MTK engineering patterns and test mode instructions Engineering mode and test mode instruction pattern: * * # 3656565 # 3646633 # # test mode: * * # 66 # old type * * # 951 # # 159 # software test initialization * * # 753 # 357 # software version # hardware tests * # 3698741 # choose the factory Settings, Engineering model # 3646633 #; * # 3656565 # One, the Internet number is not to be introduced, can not understand, had better still do not move, move also should not use two, device 1, LCD - main screen: Set contrast (setting contrast) indicates that set param (setting parameter) Numbers can be adjusted Set biasratio Set line rate Set temperature Set COLOR Diplay demo PIC GPIO3, PWM (PWM) 4, EINT (unknown) 5, ADC (analog digital converter) 6, set default level (setting default criteria) The main LCD contrast (the main screen contrast) is the Batterry (battery). 1Set UART (setting the universal asynchronous transmitter) TST config. PS config. Set the default value of the USB port for use. 1, 2, and error detection 7.2 UART POWER ON/OFF 8, the Sleep mode Enable paying Disable9, NAND Format (NAND circuit Format), is a disk formatting, dont move, otherwise data will be lost, I formatting for several times, lost all the previous photo 10 and DCM mode (1) the Enable (2) the Disable SWDBG OFF DSP LI DSP PS LI PS MCU MCU DSP RESET ( 12, PMIC 6318 (1) the Register of R/W (2) the Charger Status The Set Charger RGB KP LED BL LED Audio Misc Lcm bl setting 13, RTC XOSC (WO) three, audio 1, set mode its normal (mobile phone set is normal) even Loudsp mode (mode) loudly even Headset mode (headphones mode) 2, (1) normal finite impulse response (1-5 five optional) (2) researched (talk) to set volume, there are seven block, respectively set point (3) Ken Tone (tonic adjustable), also can adjust the volume) (4) Melody (Melody) adjust the volume (5) outside the MP3 Sound (should be adjusting ring Tone, not quite sure) 6 Microphone (mic) should be to adjust the M