主板常见故障维修案例（国外英文资料）.doc

主板常见故障维修案例（国外英文资料） No display class failure Example 1: the motherboard does not start, boot is not displayed, there is a memory alarm sound ( tick ) Cause of failure: the failure of memory alarm is more common, mainly due to poor memory contact. For example, the internal memory bar is not standard, the memory stick is a little thin, and when the memory is inserted into the memory slot, there is a certain gap; The gold finger of the memory stick is poor, the surface of the gold finger is gilded and bad, and the surface of the gold finger is thickened and the surface of the finger is thickened, causing a poor memory. The memory slot is inferior, the reed and the gold finger of the memory stick are not real and so on. The solution: open the box, with rubber carefully wipe off the gold finger of memory chips, plug memory chips down again, the memory slots on both sides of the gap filled with hot melt adhesive, prevent the oxidation of the in use process to continue. Note: be sure to unplug the hosts power cord to prevent accidental burning of memory. [example 2] : the motherboard does not start, turn on no display, and have a video card alarm (a long two short shrieking) Cause of failure: it is usually the card loose or the graphics card is damaged. Solution: open the case and replug the graphics card. To check if there is a small foreign object in the AGP slot, otherwise the graphics card will not be inserted. For the use of voice alarm boards, the content of the speech prompt should be carefully identified, and then the contents should be resolved accordingly. If the above method is handled, it may be a chip that is broken, replaced or fixed by the graphics card. If you hear di of the boot after a self-checking by display is normal but not image, plug the graphics in other motherboard, use normal, that is video card do not compatible with the mainboard, should replace the video card. Example 3: the motherboard does not start, turn on no display, no alarm sound The rea