主板检测卡代码对照表（国外英文资料）.doc

主板检测卡代码对照表（国外英文资料） Features quick The function of the indicator lamp is in Chinese meaning The CLK bus clock, whether ISA or PCI, should be kept on when an empty board (no CPU, etc.) is switched on, otherwise the CLK signal is bad. The BIOS basic input output main board runs when the BIOS is read and is shiny. The IRDY main device is ready for the IRDY signal to shine, otherwise it will not be bright. OSC oscillates the main vibration of the ISA slot, and the power on the empty plate should be bright, otherwise it will stop. The FRAME FRAME cycle PCI slot has a circular FRAME signal when the light is bright and usually bright. It is normal to turn the RST back on or press the RESET switch after the RESET switch, and if it is not inextinguish, it will be damaged by the reposition pin on the mainboard. The power of the 12V power supply panel is always bright, otherwise there is no short circuit for the voltage or the main board. The -12v power supply is always bright, otherwise there is no short circuit for the voltage or the main board. The power of the 5V power supply is always bright, otherwise there is no short circuit for the voltage or the main board. The -5v power supply is always bright, otherwise there is no short circuit for the voltage or the main board. (only the ISA slot has this voltage) 3V3 power supply is the characteristic 3.3 V voltage of PCI slot, the power on the blank panel should be bright, and some PCI slots have no such voltage, but they are not bright The main board detects the card code synopsis Look-up table required: There are three cases of special code 00 and ff and other starting codes: It has been followed by a series of other code, 00 or ff, and the motherboard is ok. If there is no error in the cmos setup, a non-serious failure will not affect the continuation of the BIOS self check, and the end result will be 00 or ff. The 00 or ff or ff or any other starting code is turned on and the main board is not running. This table is sorted b