数字电源精化（国外英文资料）.doc

数字电源精化（国外英文资料） 3 dc output stable power terms 3.1 dc power supply Power supply that does not change over time. Constant voltage/constant current power supply It depends on the load condition as a source of constant pressure source or constant current source. The crossover area of 3.3 The output value range occurs when the working pattern changes. Note: (1) the output in this area cannot be defined (2) if there is no other regulation, the overlapping area shall be brought by the load effect or the tolerance. Crossover point The intersection of two lines of stable output, represented by the nominal value, is usually the center of the overlapping area. Adjustable overlap of adjustable crossover A characteristic of constant pressure/constant current source, using it, the nominal value of two stable output values can be adjusted separately within the rating range of the power source. 3.6 control control Using variable elements or signals to determine the output of the power supply, the relevant values can change continuously or step by step. 37native control local control The power output is determined by the power supply itself. Remote control remote control Adjust the power output through external control. Note: a specific remote control method is usually specified based on the amount of signals or signals provided, such as: -- resistance control; -- voltage control; -- current control; -- digital control. Remote sampling remote sensing Using external sampling, a method of monitoring stable output from the load directly. Note: the voltage drop on the load line is compensated to the prescribed limit by the sampling circuit. 3.10 source power factor The ratio of power to source to power. 3.11 source displacement factor The base wave of the source has the power compared to the base wave of the source. Note: the displacement factor is equal to the cosine of the Angle difference between the source voltage and the base wave component of the source current. 3.12 start impact