笔记本与投影仪连接技巧和常识及问题解决方法（国外英文资料）.docVIP

笔记本与投影仪连接技巧和常识及问题解决方法（国外英文资料） Notebook and projector connection skills and common sense and problem solving methods With the integration of information technology and traditional teaching mode, the role of computers in education teaching is becoming more and more apparent. Especially laptop computers The combination of the projector, due to its small size, convenient installation and easy to carry, is becoming more and more popular among teachers. But there are a few unexpected problems in the use of this, and here are the following: One, the projector RGB port has no input signal When the projector is switched to RGB output, the RGB port is prompted for no signal input. First, the VGA connection line is not connected. The problem is on the computer if it is normal that the VGA is exported without signal. Is the VGA port broken? The general probability is small. By looking at the data, it is found that there are three kinds of output modes: 1, LCD screen output, VGA port has no output. This is the default way to think about saving power. VGA port output, no output on the screen. VGA ports and screens have output. Therefore, the computer must switch to the third output mode. Take the zhaoyang notebook computer for example, switch mode to the keyboard Fn ten. Older notebooks, such as Toshiba, switch to a hard switch on the side of the laptop. The projector has information input, but no image The laptops in class correctly under the condition of the output mode, the above problems should first check whether the computer resolution and refresh rate match the projector. We know that laptops are generally highly configured for hardware, with higher resolution and refresh rates. But if you exceed the maximum resolution and refresh rate of the projector, the above phenomenon occurs. The solution is simple, through the computer display adapter to trim both parameter values, generally no more than 600 * 800 resolution, refresh rate between 60 to 75 Hertz, projector manual for