CMOS中的硬盘信息（国外英文资料）.doc

CMOS中的硬盘信息（国外英文资料） Hard disk information in CMOS In computer CMOS also store information on the hard disk, hard disk type, main capacity, the number of cylinders, the head count, the number of each sector, the way of addressing the content, the hard disk parameters, so that the computer correctly access the hard disk. When CMOS for power or an Error occurs (start will typically prompt CMOS Checksum Error or similar information), hard disk set may be lost or mistake, hard disk access will not correct. This kind of situation we have to reset the hard disk parameters, if had to write down the hard disk parameters in advance or have some anti-virus software backup CMOS information in advance, need to manually restore; Otherwise, you can also use the HD Type Auto Detection feature of the BIOS Setup (Setup), which usually results in the right results. Its not a problem Weve a lot of time there will be some seemingly very trouble, is really just frighten yourself, namely tugs thrum, move jumpers lift a finger. There are two main types of hard drives that make you feel cold and sweaty: The system does not recognize the hard drive: This type of failure is most common, and the following error message is prompted when the self-check is completed: HDD controller failure Press F1 to Resume This means hard drives cant start, and even automated monitoring in CMOS cant detect the presence of a hard disk. When this information should focus on first check the power cord, related to the hard disk interface of the data line is damaged, loose and poor contact, the phenomenon such as reverse connection, in addition to common reason is that the hard disk of master-slave whether jumper setting error. Inspection and exclusions: Replug the hard disk power cord, data line, or switch the data line into other IDE ports for replacement tests. Failure of CMOS errors: Turn on the following information: Drive not ready error Insert Boot Diskette in A Press any key when ready... This error is cause