南天PR2打印机设置（国外英文资料）.doc

南天PR2打印机设置（国外英文资料） South day PR2 printer setup How do I get the printer configuration parameters Steps: Turn off the printer. Press the STATION2 key on the operating panel, turn on the power, wait for the printer to reset and release the key. 3. Insert a piece of A4 paper, then the printer will automatically into the paper and print printer configuration parameters, if the parameters of the involved more then one page may play not over, then need to add a piece of paper into the printer to print the current configuration parameters of complete. Turn off the printer when its finished. How to modify the printer configuration parameters Steps: It is recommended that users do not modify the configuration parameters of the printer when they are not aware of the exact meaning of each parameter. To SET UP the parameter Settings, follow these steps: To turn it off. Press the STATION1 and STATION2 key, then turn on until the printer initializes the action. Insert an A4 sheet of paper into the slot. At this point, the printer prints out a line of messages: Press STATION1 for the current parameter to select the next parameter based on the STATION2 and set the parameter as LOCAL Press the LOCAL key and the machine enters the set state. Print out the following line: MENU: configuration mode If you press the STATION1 key at this point, you will be able to identify the current parameter configuration mode and select the parameter Settings in the configuration mode. If you press the STATION2 key at this point, it will mean that the current parameter configuration mode is not selected, and the printer will print out: MENU: configure the schema IBM configuration In the same way: If you press the STATION1 key next, you will be able to identify the current parameter option ( IBM configuration ) and select the parameter Settings under it. If press STATION2 key at this moment, it will mean option does not recognise the current parameters, then the printer will print out the next option