建伍tk-378的说明书（国外英文资料）.docVIP

建伍tk-378的说明书（国外英文资料） At this point, Display b-minus (a value of 1 ~ 255 adjustable), adjust the channel selection knob to the launch indicator light, At this point, the battery voltage is detected that the voltage is below the set point and the warning signal is issued, the adjustment value is stored in the memory, and the communication machine shows the state of tUnE, End of commissioning. TK378 intercom programming and adjustment complement In 2001, phase 29, category: communications world It is very good to see the article TK378 intercom programming and adjustment written by jiang menghao in the ninth edition of this year. Mr. Jiang described the programming method, for one, machine programming and the adjustment is very convenient, when there are a lot of intercom need programming  will feel both time-consuming and laborious, There will be some mistakes. Let me introduce you to the lazy approach of wireless replication. Heres how it works: The copy side operation takes a walkie-talkie that has set up the frequency and various functions, while holding down the LAMP and the DIAL key, Turn on the power for two seconds and then enter the dealer mode, the screen shows SEL, and then press the MONI key into the wireless replication mode. The frequency that is displayed at this time is the initial frequency that corresponds to a variety of models, and then to the lowest frequency of the desired frequency (generally, an integer that is not above the lowest frequency, This is easier to set up, and its not easy to make mistakes. The operator operates the same way. It is important to note that the frequency modulation should be the same as the replicate, otherwise the wireless replication cannot be achieved. You can start copying all the intercom that you need to program. Press the PTT key of the replicate side and start sending the data immediately, At this point, 00C10nE, the transmitter red indicator lights. After receiving the data, the receiver will display 00C10nE a