硬盘的数据线或电源线问题（国外英文资料）.docVIP

硬盘的数据线或电源线问题（国外英文资料） If in the Standard CMOS the Features cant see the hard disk drive and related information, or hard disk type characters into a garbled, for example, was supposed to be IC35L060AVVAWA07 - O, but has turned into a IC# l0 5 0 avfa 7-0, to check the parameters of the hard disk, and nothing at all, so in general there are two reasons: The data line or power line problem of the hard disk For todays big hard drives, they use the 80-core data line. When appear in the BIOS cant see the hard drive, or drive model, the phenomenon of the gibberish, first consider replacement method is used to replace a confirm there is no problem of cable, and carefully check data line contact with hard disk interface, the mainboard IDE interface, view motherboard IDE interface and whether the hard disk data interface, slanting end needle, and so on and so forth. If the problem is caused by cable and power supply connection, generally after replacement cable and eliminate the problem of poor contact, can see the hard drive in the BIOS, the hard disk also can guide. The hard drive itself is a problem When by changing the data line, eliminate a poor contact still cant see the hard disk, or drive model garbled words, only by replacing method to check whether there is something wrong with the disk itself, the specific method is: will the fault disk articulated in other work in the computer, to see if the hard drive to work, if can work normally, then hard disk itself is no problem; If the hard drive is still undetected, the hard drive has had a serious malfunction and it is recommended to be returned to the manufacturer for maintenance. Note: if the system is installed in the disk, then also need to check for hard drive jumper setting, lest because the jumper setting error and lead to the existence of the system cant detect hard disk. The setting method of the hard disk jump line can be obtained by looking at the instructions. This hard disk cannot lead hard disk failure, the