行幅不正常的检修（国外英文资料）.docVIP

行幅不正常的检修（国外英文资料） In the occipital circuit, the diode modulation (DDD) type circuit is more complex, the forms are varied and the maintenance is relatively difficult. The fault phenomena of horizontal sleeper circuit fault are: (1) the line is abnormal; (2) the aberrant and occipital distortion occur simultaneously; (3) the line is normal and the pillow is distorted. A school, in DDD type horizontal pillow circuit, the grating lines of size is determined by pincushion correction capacitor voltage levels on both ends, and on the pincushion correction capacitor on the voltage by the working state of the field frequency parabolic wave power amplifier circuit decision, on the other hand is determined by the line of the output circuit. Therefore, we can adjust the amplitude potentiometer to make the field wave changes. At this time. If the line as the picture changes (but cannot achieve ideal state), explain pincushion correction capacitor voltage can change, parabolic wave field frequency circuit to work, the basic of the cause of the problem may be in parabolic wave amplification bias circuit or output circuit; If the timing is unchanged, the fault is caused by the sleeper circuit. Type in 12 c bus control type DDD level pincushion correction circuit, when the line of the abnormal change of 12 c bus H - WID data size, if the line can change, also explain basic field frequency parabolic wave amplifier circuit to work, the 12 c bus control is normal also, besides the field frequency parabolic wave circuit because at this moment, you should also consider line output circuit working condition; If the adjustment of the h-wid data is large, the row amplitude does not change, and the abnormal fault is caused by the sleeper circuit. Line width adjustment is change by H - WID item data field frequency parabolic wave tube amplifier working state, so change the H - WID data size, measurement field frequency parabolic wave amplifier tube base voltage, if it can be normal change wi