通信机房UPS供电系统配置方案（国外英文资料）.docVIP

通信机房UPS供电系统配置方案（国外英文资料） Talk about the configuration of UPS power system in the communication machine room [date: 2011-09-19] Uninterruptible power supply (UPS) is widely used in communications. It is becoming more and more common to install UPS (uninterrupted power) in the communication machine room. A well-designed UPS supply system can provide high quality power to the load. How to build a reasonable and safe UPS supply system is a concern. This paper discusses the various aspects of UPS power supply system configuration, which can be used for peer reference. The requirement of the pre-ups power supply system UPS can provide high precision voltage regulator to the load, frequency stabilization, small waveform distortion degree of the high quality of power supply, and with the static bypass switch can uninterrupted power supply. But to do that, the quality of its front power supply cannot be ignored. We should consider the following aspects when designing a pre-class power supply system: (1) the power supply system should not be too poor, and the voltage and frequency should be stable in normal range. Generally speaking, the input voltage range of a large capacity UPS host should be 380V plus or minus 15%. Low voltage will make UPS spare batteries frequently discharge, which will eventually shorten its service life due to a prolonged period of under-voltage charging. On the contrary, the voltage is too high, causing the inverter to be damaged. For the by-pass input, the voltage and frequency fluctuation also has a certain range, generally for the rated voltage plus or minus 10%, rated frequency plus or minus 15%. If the previous level of power supply changes too much, the switch between the inverter and the by-pass power supply is forbidden or discontinued. Therefore, if the communication machine room level power grid in the voltage range before it reaches less than required, should be in before UPS level configuration suitable anti-interference ac regulated powe