选择机电一体化设计基础判断题答案（国外英文资料）.docVIP

选择机电一体化设计基础判断题答案（国外英文资料） 3: the resolution of the D/A converter is the number of decimal digits that the converter can convert. (c) 4: the delay time of the software to shake should be less than the jitter time. (c) The minimum basic sub-function or the minimum unit that meets the functional requirements is called the functional element. (d) 7: you can measure the quality of the bus using bus width, bus frequency, and bus bandwidth. (c) The moment of inertia will reduce the mechanical load, decrease the system response speed, and decrease the sensitivity of the system. (c) 10: grating measurement is a contact measuring method. (c) 12: the dc servo motor has the armature control, the magnetic field controls the speed adjustment and the mixing speed adjustment. (d) 14: a single buffer is DAC 0832 one of the two input registers in a direct way, and the other in a controlled way of latches, or two input registers and controlled manner. (d) 15: proportional controller is essentially an amplifier, the greater the gain, adjust action, the more rapid response of the system, the better, but the gain value is too large, will cause the system unstable. (d) 16: the elements that constitute the system of mechanical and electrical integration have the control system, the power plant, the detection device, the actuator, the mechanical body. (d) 17: during the rotation of a wave generator, the number of cycles in a slight deformation on the soft wheel is inconsistent with the number of bumps on the wave generator. (c) 18: the accuracy is a performance index of the system control precision, no matter the size of the steady-state error, request system under the action of the input signal, the response speed after getting into the steady state after state process. (c) 19: sampling time is the time that is measured for the measured parameters. (d) 20: software to shake way is after the switch state is detected, delay for a period of time line for testing, if testing twice to the same s