阳光灿烂的博客 ACS800调试（国外英文资料）.docVIP

阳光灿烂的博客 ACS800调试（国外英文资料） The ACS800 converter debug step by default classifies 2011-01-01-09 11:29:57 reading 303 comments 2 words: large and small subscriptions. A simple local startup of the converter First, make sure that it is open and closed, and the contactor is electric. By LOC/REM, the converter is a local control mode Press FAR into the control panels parameter Settings mode Select the 99 parameter group with the double arrow key, and then select 2004 with the single arrow key, ENTER 99.04 motor drive mode (DTC) The DTC inverter set a fixed value for speed (in most cases this pattern) The value of the SCALA inverter is frequency Select the mode and press ENTER to confirm (unreturn by ACT) ACT the ACT back to the present state Press REF, select the upper and lower adjustment key, ENTER the specified parameter, press ENTER to confirm Press the boot button, and the converter starts This completes the simple local run of a converter If you need to replace the displayed actual signal with the other actual signal, you can follow these steps: Press ACT to enter the actual signal display mode; Select the parameter line that needs to be changed, press ENTER. Press a single double arrow to select the parameters to display or change the group of parameters. (a few common signals: The actual SPEED of 01.02 motor The actual value of the output frequency 01.03 is FREQ The code for the LAST failure of the 03.20 converter was LAST FLT. Press ENTER to confirm and return the actual signal display mode. (cancel the ACT directly) Upload and download How to set the machine to the CDP -312 operation panel: Activate the communication of optional devices Verify that 98.02 COMM. MODULE LINK is set as FIELDBUS 98.07 COMM PROFILE is set to ABB DRIVES Switch from LOC/REM to L local control; Press the FUNC into the functional mode; Press the single double arrow key into the UPLOAD function, press ENTER to perform the UPLOAD, and then automatically switch to the current signal display m