漳州某110k变电站一次系统电气部分设计.doc

东北农业大学学士学位论文 学号：166130104005 110kV一次系统电气部分设计 110kV a system electrical design 学生姓名：罗 南 生 指导老师：林 艳 玲 所在院系：网 络 教 育 学 院 所学专业：电气工程及其自动化 研究方向：电力系统 东 北 农 业 大 学 中国·哈尔滨 2013年02月 摘 要 我国电力建设经过多年的发展，系统容量越来越大，短路电流不断增大，对电气设备、系统内大量信息的实时性等要求越来越搞。该变电站的建成，不仅增强了当地电网的网络结构，而且为当地的工农业生产提供了足够的电能，从而达到使本地区电网安全、可靠、经济地运行的目的。 本论文《110kV某市变电站一次系统设计》，首先通过对原始资料的分析及根据变电站的总负荷选择主变压器，同时根据主接线的经济可靠、运行灵活的要求，选择了两种待选主接线方案进行了技术比较，淘汰较差的方案，确定了变电站电气主接线方案。 其次进行短路电流计算，从三相短路计算中得到当短路发生在各电压等级的母线时，其短路稳态电流和冲击电流的值。再根据计算结果及各电压等级的额定电压和最大持续工作电流进行主要电气设备选择及校验（包括断路器、隔离开关、电流互感器、电压互感器等）。 最后，并绘制了电气主接线图、电气总平面布置图、防雷保护配置图等相关设计图纸。 关键词：短路电流计算 ?电气主接线设计? ?电气设备选择? 设计图纸 Abstract After many years of developing electric power constructions in china,and as the capacity of the entire system grew, short-circuit current is getting bigger and bigger.which requires higher standards for the electric devices and the instantaneity of the system.the completion of building this converting station not only strengthened the structure of the local power grid but also fulfilled the needs of the native industries.the purpose to run the local power grid with safety and stability is achieved. Firstly,based on the analysis of the original data and depended on the total load of the converting station,This thesis110KV The design of a coverting station in Xcity presents that how the main transformer was chosen.and how the main wiring scheme was finally chosen after comparing carefully with another plan,for the purpose of meeting the requirements ,which is economic,reliable and flexible. In the second place of this thesis,it presents the value of steady state short-circuit current and striking current during a short out,occurred on the bus with different voltage levels. And based on the results,nominal voltage and Maximum continuous working current,how to verify and select main electrical euipment was presented.(including breaker,disconnector, voltage transformer and current transformer) The last part,is the pre