钢结构取样(外国英文资料).doc

钢结构取样(国外英文资料) The method and the number of samples are obtained from the construction of steel structure Part one: witness the sampling test First, the quality of the steel For the steel that belongs to one of the following conditions, the sample reinspection of the chemical composition analysis and mechanical properties of the steel shall be tested: (1) imported steel from abroad; (2) steel mixing; (3) the thickness of the board is equal to or greater than 40mm, and the design has a thick plate to the performance requirement. (4) the structural safety level of the building is one level, and the steel used by the main force components in the large span steel structure; (5) to design the steel required for reinspection; (6) steel that is suspicious of quality. Chemical composition analysis (master control project) (1) inspection indicators: carbon, silicon, manganese, sulfur, phosphorus and other alloy elements (2) according to the standard: samples of steel and iron chemical components for sampling and making samples GB/t20066-2006 Standards for architectural inspection GB/T50344-2004 (3) sampling method and quantity: the analysis of the chemical composition of the steel, the analysis of the component analysis or the main component analysis may be carried out according to the requirement. The sampling method should be used to ensure that the analysis sample is representative of the average chemical composition of the sampling products. Analytical samples should remove surface coating, dehumidification, dust removal and other forms of pollution. Analytical samples should be avoided as far as possible from the pores, cracks, loose, burrs, folding and other surface defects. The quality of the preparation analysis should be large enough to allow for the necessary retesting. The quality of the sample of the chip or powder is 100g. The method of drilling, cutting, driving and flushing is available. The sample should be cut or broken, and then pulverized with a crusher or