1.恒温槽测试思考题答案2(国外英文资料).docVIP

1.恒温槽测试思考题答案2(国外英文资料) Thermostat assembly and performance testing First, experimental skills 1, to set the temperature to 25 degrees, how to adjust the thermostat? The use and adjustment of 2, Backman thermometer. Reference answer: 1. temperature setting: (silver water conductivity meter adjustment) If room temperature is 20 DEG C, to set the temperature of 25 DEG C, following the adjustment method: first unscrew the mercury thermometer The upper end of the spiral adjusting locking screw cap, and then moving the magnetic screw adjusting cap, the temperature indicating nut located approximately at 22 DEG C. The relay is switched on the power, turn on the switch, open the heater and the stirrer to work, look at the thermometer. When reached 24 degrees Celsius, again rotating magnetic spiral adjustment cap, make contact with mercury column is just connected with the short open. It is time to Slow heating until the temperature reaches 25 degrees Celsius, and then tighten the locking screw. 2. regulation of Backman thermometer: The experiment with scale reading method This method is the direct use of the upper part of the Backman temperature scale thermometer, without additional thermostatic bath to regulate its operation step It is as follows: first Backman thermometer inverted, mercury and mercury above the auxiliary tank below the mercury ball in Shui Yinlian Then, standing over, put in the constant temperature trough has constant temperature in 5 minutes, when Mercury stays in the meter under the auxiliary mercury storage tank The scale; inverted, the mercury rose 2.5 in the small scale based on the original lattice (equivalent to about 5 degrees), it immediately Li, take off, Backman will be back on the thermometer thermostat, the mercury column scale in 1~4 can be. Two, ask questions: 1. thermostat structure, components of the role. 2. how to improve the sensitivity of the thermostat? The structure and characteristics of the 3. Backman thermometer. Method of adjust