家电维修秘籍(国外英文资料).docVIP

家电维修秘籍(国外英文资料) The barrier is not clear. Failure analysis and repair: this is generally the water pressure switch poor performance or leak air line, make the gas collecting indoor air pressure decreases, when fill the bucket in the inland waters have not to the specified location, water pressure switch contact action in advance, bringing the total drainage time, lead to failure of drainage is not clear. Just try to find a leak in the air line and seal it with a 401 (k). If the water pressure switch is damaged, the water pressure switch should be replaced. So its a long time when the water is tied. Analysis and maintenance: the brake band of the fault system can not hold the brake wheel on the shaft, which causes the brake friction to decrease. The specific cause and processing method is: (1) the brake belt on the clutch is installed, the lining wear or the fastening screw loose. Just reinstall or replace the brake belt. (2) the brake spring loosens, breaks, or loses elasticity. Just reload or replace the brake spring. (3) the brake lever is held back by a ratchet, which makes the brake band not hold tight. Simply adjust, repair, or replace the fork in the position of a ratchet. (4) the electromagnet moves the iron core to be unable to hold out completely, so that the brake lever cannot be reinstated. As long as you remove the rust from the electromagnet and remove the rust or change the electromagnet. Reason 9: when the water is off, there is a large vibration noise. Analysis and maintenance: the specific cause and method of causing the vibration noise of the bucket is: (1) there is clutter between the bucket and the washing bucket. Just remove the clutter. (2) when the bucket has broken or leaked, it loses the balance when the bucket turns. Just replace the balance. (3) remove the bucket flange and tighten the screw or break it. Just tighten or replace the flange. (4) the dehydration bearings are severely worn or loose. Simply tighten or replace the dehydration bea