摆线针轮减速机维护检修规程(国外英文资料).docVIP

摆线针轮减速机维护检修规程(国外英文资料) Specification for maintenance and overhaul of cycloidal pin gear reducer 1 General Provisions This regulation applies to the maintenance and overhaul of cycloidal pinwheel reducer (hereinafter referred to as reducer), and the maintenance and overhaul of cycloidal gear reducer can also be referred to execution. 2 inspection interval 2.1 overhaul category Repair and overhaul includes minor repairs, three. 2.2 inspection interval The period of inspection and maintenance is shown in Table 1 Table 1 h Overhaul category Minor repairs Repair Overhaul Maintenance interval Four thousand and three hundred Thirteen thousand Twenty-six thousand 3 overhaul content 3.1 minor repairs 3.1.1 cleaning body oil dirt and debris, replacement of lubricating oil or grease. 3.1.2 check and fasten bolts on each part. 3.1.3 check and eliminate the oil leakage in the joint surface and the seal. 3.2 medium maintenance 3.2.1 includes minor content 3.2.2 inspection, cleaning all parts of the body, wash oil dirt and debris. 3.2.3 remove lubricating oil and dredge oil circuit. 3.2.4 check, replace each department bearing (especially the arm bearing) and the skeleton rubber oil seal. 3.2.5 check, replace the dip pad, paper pad, oil resistant rubber pad and O type sealing ring. 3.2.6 check the pin sleeve, pin pin, pin pin and pin sleeve of the output shaft. 3.2.7 look for the positive coupling to ensure the coaxiality of the reduction shaft and the driven shaft. 3.3 overhaul 3.3.1 includes medium maintenance 3.3.2 inspection, repair or replacement of cycloid gear, needle tooth shell, output shaft and rotating arm (eccentric sleeve) and other key parts. 3.3.3 inspect, repair or change the base, fastening ring, isolating ring, cam and so on. 4 preparation before overhaul 4.1 technical preparation 4.1.1 manuals, drawings and related standards and other technical data. 4.1.2 records of operation, repair, defect, hidden trouble, malfunction, malfunction, etc.. 4.1.3 reducer temperat