灰土垫层质量检验过程中压实系数(国外英文资料).docVIP

灰土垫层质量检验过程中压实系数(国外英文资料) I checked a lot of specifications, did not explain the compacted soil compaction coefficient test requirements 1. code for design of building foundations, GB 50007-2002 Article 10.1.2 in the process of compaction fill, should be stratified sampling inspection of soil dry density and water content. There should be a test point of each 50-100m^2 area, according to the compaction coefficient test results obtained, shall not be less than the provisions of table 6.3.4, on the gravel soil dry density of not less than 2.0t/m3. But this one should be aimed at foundation detection, not suitable for large area backfill detection 2. technical code for building foundation treatment, JGJ 79-2002 4.4.3 the construction quality inspection of the cushion ring method, the sampling points should be at the depth of 2/3 in each layer thickness. The number of test points, big pit every 50 ~ 100m^2 should not be less than 1 of the foundation trench inspection point; every 10 ~ 20m should not be less than 1 points; every single column should not be less than 1. When the construction quality of cushion is checked by penetration tester or dynamic penetration test, the distance between check points of each layer shall be less than 4m. But this one is aimed at the foundation pit which uses the change filling cushion method, and also does not apply to the large area backfill detection 3. code for construction quality acceptance of building foundation engineering GB 50202-2002 The most suitable chapter is the sixth chapter, but there is no explanation about the test requirement of compaction coefficient 4.1.5 on the foundation of sand and gravel foundation, geosynthetics foundation, fly ash foundation, dynamic compaction, foundation grouting, preloading foundation, the completion of the results (the foundation strength or capacity) must meet the design requirements of the standard. Inspection quantities shall not be less than 3 points per unit of work, at least 1 points