煤气管道安装方案(国外英文资料).docVIP

煤气管道安装方案(国外英文资料) Installation of indoor gas pipeline 1 range The process standard is applicable to the installation of indoor low-pressure gas pipes and appliances for work pressure not greater than 0.005MPa. 2 construction preparation 2.1 material requirements: 2.1.1 gas transmission and distribution projects used in the pipe, pipe fittings, sealing materials and other materials should be in line with the existing national standards. The pipe, pipe fittings and subsidiary materials shall have the factory certificate and shall be re examined at the site. 2.1.2 galvanized carbon steel and pipe fittings specifications and types should meet the design requirements, galvanized pipe inside and outside the uniform, no corrosion, no flying thorn. Tube without partial deduction, arbitrary deduction, incomplete or inaccurate thread angle phenomenon. Both pipe and fittings should have factory certificate. Galvanized carbon steel pipes and fittings shall be used in the installation of indoor gas pipelines. 2.1.3 carbon steel pipe, seamless steel tube. Pipe material shall not be bent or rusted without flying thorns, heavy leather and uneven surface. 2.1.4 valve should be used in the current national standards applicable to the transmission of gas medium, and has good sealing and corrosion resistance of the valve. Indoor generally choose cock or ball valve. Valve specifications, models should meet the design requirements. Its appearance: Casting rules, smooth surface, no cracks, pores, shrinkage, slag eye; sealing surface without any defects, the surface roughness and the degree of agreement to meet the standard requirements; the sealing surface of flange straight through valve should be parallel to each other; internal thread joint center line straight through valve should be in the same line, angle deviation shall not exceed 2 degrees; internal thread joint center line angle type valve is not vertical, the deviation should not be more than 2 degrees; the height of filling pres