结构图中的常见问题(国外英文资料).doc

结构图中的常见问题(国外英文资料) Structure description 1, a description of the building elevation and elevation structure: floor elevation shall be the building floor level reducing building surface layer thickness should not be simple instructions for building structure with elevation elevation, should look at the architectural detail to set; if the construction drawing of the floor elevation line in interface, then building note the floor elevation is the structure elevation, safe height attention building railing, railings, window, building marked buildings should be considered the effect of the thickness of the building marked height = safe height + building surface layer thickness (50mm), and mark height = + building height of the hole surface layer thickness, so the size of building relatively fragmented, general building designers did not do so; general construction drawing in the floor surface and the elevation line to complete the doors and windows in the standard high top surface structure in the construction, so that the structure of standard floor High = building floor elevation - building surface layer thickness control of floor beam high = building dimension - building surface layer thickness; if the construction drawing of the floor elevation line in building complete surface, and the description of the structural design and structural elevation with the building elevation, is completely mistaken, not only the building and structural contradictions, and have the tailgate, railings, window safety is not high enough, it is also less height of a building surface layer thickness, causing great confusion in the construction of the party, do the lintel construction experience when the door hole elevation adjustment over (sometimes unintentional, it does not know wrong, only in the installation height control by lintel building doors and windows drawing instructions from the floor to the measurement results, is a fluke), but if the openings is caused to change the low door