辅机3(国外英文资料).docVIP

辅机3(国外英文资料) The first problem: the gear pump is not suitable for water is mainly because of ________. A. leakage is serious B. efficiency is too low C. wear badly D. corrosion is serious Answer: C Second questions: the following statements about: 1. The steering gear pump, II suction depends on the direction of the gear meshing gear. One side exit and discharge pipe, which ________. A. Is right B. II is correct C., I and II are correct D., I and II are incorrect Answer: A The third problem: the main internal gear pump leakage occurred in ________. A. gear clearance B. addendum clearance Between the meshing teeth of C. D. shaft seal Answer: B The fourth problem: the general external gear pump has ________. A.2 only rolling bearings B.4 only rolling bearings C.2 only plain bearings D.4 only plain bearings Answer: B The fifth problem: gear pump bearing lubrication usually rely on ________. A. quote oil from the discharge end B. oil leakage in the end clearance C. with grease D. use lubrication free bearings Answer: B The sixth problem: oil ________ lubrication gear pump bearing. A. comes from the oil leak in the top clearance of the teeth through the suction port B. comes from the oil leakage in the gear end clearance, through the suction port C. comes from the oil leak in the top clearance of the teeth through the discharge port D. comes from the oil leakage at the end clearance of the gear and passes to the vent Answer: B The following seventh questions: on the gear pump bearing statement is not true ________. A. oil lubrication by end clearance B. uses thrust bearings to bear radial and axial forces C. grease can be taken back to the suction end D. is not allowed to use plain bearings Answer: B Eighth title: seal the common gear pump is the most commonly used ________. A. soft packing seal B. mechanical seal C. lip seal D.O shape sealing ring Answer: C Ninth questions: (seal lip seal) and the inner diameter of the shaft diameter should be compared to ________. A. is