风机轴承故障原因与处理方法(国外英文资料).docVIP

风机轴承故障原因与处理方法(国外英文资料) Cause and treatment method of fan bearing fault According to incomplete statistics, cement plant fan when the abnormal vibration of high failure rate of 58.6% due to unbalanced vibration will cause the fan running, one of them. Bearing adjustment improper set fit, will lead to abnormal temperature rise of bearing and the vibration. If a cement plant changes the blades during the maintenance of the equipment. Both sides of the wheel are fixed with the bearing bearings. Commissioning occurs again free end bearing high temperature, the vibration value is on the high side of fault, disassemble the bearing on the cover, manual slow rotary fan, found in the axis of a particular position of bearing roller, in the load section also have scroll case. So can determine installation clearance of bearing running clearance changes on the high side and may be insufficient. The internal clearance of the bearing is only 0.04 mm, and the uranium eccentricity is 0.08 mm. To avoid, because of the large bearing span around a shaft deflection or bearing installation Angle error is more difficult, therefore, a large fan USES can be adjusted automatically central spherical roller bearings. But when the inside clearance of the bearing is not sufficient, the internal rolling part of the bearing will be affected by the motion space, and the vibration value will increase. Bearing internal clearance decreases with increasing with the tightness, unable to form the lubrication film, when the bearing running clearance due to temperature drop to zero, if the heat generated by the bearing running is still greater than the heat dissipation, bearing temperature will climb quickly, at this time, if not immediately stop, bearing will be burning, with tight of bearing inner ring and the shaft is in this case, bearing the cause of the abnormal high temperature operation. When processing, rearrange the tension of the shaft and inner ring, and then take 0.10 mm clearance. Reinstall the