高级管道工理论知识试卷(国外英文资料).docVIP

高级管道工理论知识试卷(国外英文资料) Senior plumbing theoretical knowledge test (H-2) objective questions; partial answers Choice question Hydraulic tube bender is generally used only for bending outer diameter not exceeding (A) mm tube A.44.5 B. 45. 5 C. 46. 5 D. 47. Five The bending radius of hot bend pipe shall be no less than (A) times of the outer diameter of the pipe A.3.5 B. 4 C. 4. 5 D. Five When using an electric bender, the bent mandrel must be placed in the pipe when the outside diameter of the bent pipe is greater than (C) mm. A.80 B. 70 C. 60 D. Fifty It is generally stipulated that the tube wall thinning rate shall not exceed (C) when the pipe is bent A.5% B. 8% C. 15% D. 20% When the temperature changes of the steel tube (T) less than (B), can not be considered compensation. A.300C B. 320C C. 340C D. 360C The stretching deviation of the pre stretched waveform expander shall not be greater than (A) mm. A.5 B. 10 C. 15 D. Twenty One end of the lining sleeve of the wave expansion device is welded with the wave wall, and the other end can be (C) A. fixed, B. Welding fixation C. Free mobile D. Thread fixation When the square expansion device is in place, the tension deviation shall not be greater than (B) mm. A. + 5 B. + 10 C. + 15 C. + 20 Different flow rates have the diameter corresponding to the economic flow rate, which is the A of the flow A. economic pipe diameter B. Economic flow C. Nominal diameter Nominal flow rate of D. In the pipe network, in order to prevent damage caused by water hammer, the highest flow rate is (C) A.0.5-0.7m/S B. 1-1. 6m/S C. 2. 5-3m/S D.3-3.6m/S For gas, hydrogen, low pressure air and other medium pipes, the pressure gauge is used (B). A. spring tube B. Diaphragm type C. Acetylene type D. Oxygen type The rotor flowmeter is suitable for pipelines with pressure no larger than (B). A.0.098Mpa B1. 96Mpa C. 5. 88Mpa D. 6. 3Mpa U tube pressure gauges shall be located within the range of ambient temperature (C). A.10-500C B. 15-600C C. 10-600C D.