一建笔记(国外英语资料).docVIP

一建笔记(国外英文资料) 2014.7.2 In order to purge media 1, nominal diameter greater than or equal to 600 liquid gas cleaning. 2, the nominal diameter of less than 600 liquid water cleaning 3, the nominal diameter of less than 600 air cleaning. 06:48 In 4, the steam pipe steam cleaning. 5, non thermal pipeline shall not use steam cleaning. Blow wash general provisions Qualified 1, pipeline pressure test, the construction unit of the organization, purge purge scheme. 2, check the pipe support and hanger firmly, not allowed to purge the isolation equipment. 3, the valve in the pipeline pressure test is not involved in the purge, purge purge valve before protected, not before the installation hole plate and flange connection valve, throttle valve, safety valve, main valve, valves, instrumentation, welding instruments should be removed through the bypass valve head and valve seat fire protection set. 4, the order of supervisor, branch pipe, pipe transportation. Pipeline pressure test 1\ 1, pipeline pressure test should be in heat treatment, nondestructive testing, hydraulic or pneumatic hydraulic test, can not can not do the occasional Design Institute to pressure. Do pressure test of brittle materials. Hydraulic test 1, clean water as the medium, the chloride ion in water is less than 25ppm 2, temperature is not lower than 5 degrees higher than the corresponding transition temperature of metal materials, prohibited materials testing temperature close to brittle transition temperature. 1.5 times 3, steel or non-ferrous metal pipeline design pressure, not less than 0.4Mp. 4, the test pressure for 10 minutes down to 30 minutes, the design of pressure regulator with no leakage, no pressure. 5, without pressure. Air pressure test 1, air or inert gas, non-toxic, non flammable, dry gas. Air pressure test for 1.15 times the design pressure. 2, before the experiment, must use the air and test, the test pressure 0,2Mp 3, test pressure rose to 50%, check whether there is leakage abnormal, a