主蒸汽压力变化影响(国外英语资料).docVIP

主蒸汽压力变化影响(国外英文资料) ? 1. increase in main steam pressure are the main influence on operation: In the main steam temperature is constant, the main steam pressure increases, the unit enthalpy increases, improve the economic operation of the. But when the main steam pressure exceeds the range limit, will be a direct threat to the safety of the unit, the following main points: (1) unit at the end of the steam humidity grade increases, the working conditions of the end stage of blade deterioration, water erosion. (2) to adjust the level of enthalpy drop increase, will cause the overload control stage moving blade. (3) will cause the main steam pressure parts stress increases, will shorten the service life of the components, and may cause deformation of the parts, so that the damaged parts. Handle： (1) the main steam pressure increased to 13.23MPa, should contact the recovery boiler main steam pressure and report value; (2) the main steam pressure increased to 13.72MPa, should immediately report the value of long, and take measures to restore normal, and to record the delay time. The 2. main steam pressure reduction mainly influence on operation: (1) in the main steam temperature is constant, the main steam pressure is reduced, the entire unit enthalpy decreases, the economic operation of the lower. (2) the main steam pressure is reduced, if the valve opening is unchanged, the amount of steam entering the turbine decreases, the stress levels of leaves will be reduced, the axial thrust will be reduced, the unit power will increase with flow rate decreases. No impact on security of the unit. (3) main steam pressure is reduced if the unit issued by the power is not reduced, even to a rated power, it will make the whole machine steam flow exceeds the rated value, if the pressure of each monitoring section exceeds the maximum allowed value, will make the axial thrust is too large, it is dangerous, not allowed. Handle： (1) the main steam pressure is lower than the set pressure,