喷油泵类测量方法工艺资料,喷油泵类强力型喷油泵(含加工方法)(国外英语资料).docVIP

喷油泵类测量方法工艺资料,喷油泵类强力型喷油泵(含加工方法)(国外英文资料) The method of measuring the prestroke and oil filling Angle of the pump [abstract] a fuel injection pump stroke and oil supply Angle measurement method, first to exclude air compressed inside the fuel injection pump, then the high pressure fuel injection, forming high pressure within the fuel injection pump, and eventually drain into the low pressure fuel to the fuel injection pump, and turn the camshaft, at the same time, record the fuel injection pump export pressure change and camshaft rotating Angle, according to the change of the fuel injection pump outlet pressure and the oil supply starting point, and the corresponding to the position of the camshaft. According to the position of the camshaft and the position of the pump pump first cylinder, the prestroke and the oil filling Angle are calculated. This technique overcomes the shortcomings of existing technical workers, and the detection efficiency and the test results are more reliable and more accurate than traditional methods. And before the detection of pretravel, it is not required to remove the oil valve core of the first cylinder of the pump, and avoid the secondary pollution of the oil pump. No. 069 energy-saving Ⅰ fuel injection pump camshaft [abstract] energy-saving Ⅰ number is diesel fuel injection pump camshaft plunger type fuel injection pump assembly, one of the important parts for domestic small power di diesel engine. The CAM lift increased to 8.5 mm, making the oil rate significantly higher. Through the engine, engine combustion improvements, a significant reduction in fuel consumption, emissions targets such as degree also improved, achieve the goal of energy saving and environmental protection. 098 electrically controlled direct synthetic multi-cylinder injection pump assembly [abstract] this technology provides a synthetic multi-cylinder injection pump assembly that can be mounted on the engine with a single or flange. As a carrier, the low pressure oil