电伴热施工(国外英语资料).docVIP

电伴热施工(国外英文资料) Documents from the network, I collected, finishing, and if there are omissions, errors, but also please correct me! Electric tracing construction (a) design drawing There should be a complete design plan before construction The following information shall be included in the drawing: 1, the line number, the power supply points with rectangular lattice 2 、 the type and length of electricity required by the line (unit: m) 3, the length of the length of the pipeline per meter, the length of the tropical (unit: meter), that is, winding factor 4, each valve required electricity, tropical length (unit: m) 5. List of accessory materials for heating system 6, temperature control system parts list 7. Material list for construction 8. Design parameters and specifications of thermal insulation materials adopted (two) preparation before construction; (A) piping systems 1 、 the piping system and equipment have been completed 2, rust proof anti-corrosion coating has dried 3 、 piping system construction specification is consistent with the design drawings 4. File all burrs and corners (B) electrical heating and fittings 1 、 whether the surface of the electricity tropics is damaged or not 2, electric tropical good insulation properties (requirements of insulation resistance in 1000VDC test with the shaking table of no less than 20M Ohm) 3 、 the type of the electric hot strip and all the fittings are in accordance with the design requirements (C) site preparation 1 place a coil of hot wire and reel on a bracket and place it near one end of the line 2, along the pipe cloth distribution tropical, and avoid: * place the hot air on the burr and corner * pull the electrically heated tropics vigorously A foot or weight placed in the electric tropics (three) single electric hot zone construction method 1 glass fiber pressure sensitive tapes or aluminium tapes are fixed to the pipe at about 50Cm every day 2, flat as far as possible to the tropical electricity attached to the lo