j-link令集.docVIP

j-link命令集 Available commands are: ---------------------- f Firmware info h halt g go Sleep Waits the given time (in milliseconds). Syntax: Sleep delay s Single step the target chip st Show hardware status hwinfo Show hardware info mem Read memory. Syntax: mem Addr, NumBytes (hex) w1 Write 8-bit items. Syntax: w1 Addr, Data (hex) w2 Write 16-bit items. Syntax: w2 Addr, Data (hex) w4 Write 32-bit items. Syntax: w4 Addr, Data (hex) wm Write test words. Syntax: wm NumWords is Identify length of scan chain select register ms Measure length of scan chain. Syntax: ms Scan chain mr Measure RTCK react time. Syntax: mr q Quit qc Close JLink connection and quit r Reset target (RESET) rx Reset target (RESET). Syntax: rx DelayAfterReset RSetType Set the current reset type. Syntax: RSetType type Regs Display contents of registers wreg Write register. Syntax: wreg RegName, Value SetBP Set breakpoint. Syntax: SetBP addr [A/T] [S/H] SetWP Set Watchpoint. Syntax: Addr [R/W] [Data [D-Mask] [A-Mask]] ClrBP Clear breakpoint. Syntax: ClrBP BP_Handle ClrWP Clear watchpoint. Syntax: ClrWP WP_Handle VCatch Write vector catch. Syntax: VCatch Value loadbin Load binary file into target memory. Syntax: loadbin filename, addr SetPC Set the PC to specified value. Syntax: SetPC Addr le Change to little endian mode be Change to big endian mode log Enables log to file. Syntax: log filename unlock Unlocks a device. Syntax: unlock DeviceName Type unlock without DeviceName to get a list of supported device names. nRESET has to be connected ---- CP15 ------------ rce Read CP15. Syntax: rce Op1, CRn, CRm, Op2 wce Write CP15. Syntax: wce Op1, CRn, CRm, Op2, Data ---- ICE ------------- Ice