利用纠错编码的同频调制混合信号单通道盲分离.pdfVIP

第31 卷第9 期 电 子 与 信 息 学 报 Vol.31No.9 2009 年9 月 Journal of Electronics Information Technology Sept..2009 利用纠错编码的同频调制混合信号单通道盲分离 涂世龙 陈越新 郑 辉 (西南电子电信技术研究所 成都 610041) 摘 要：该文建立了同频调制编码混合信号的基本模型，提出了基于M-PSP 的利用编码信息的单通道盲分离算法， 重点研究了状态格图的构建、分支度量的计算和信道响应的跟踪。仿真结果表明，利用编码的单通道盲分离算法可 以获得比不利用编码更好的性能，对于1/2 码率的卷积编码BPSK 信号，在误码率为10−4 时，信噪比改善可达到 2 dB 左右。 关键词：信号处理；盲分离；单通道；纠错编码；M-PSP 中图分类号：TN911.7 文献标识码：A 文章编号：1009-5896(2009)09-2113-05 Exploiting Error-control Codes in Single-channel Blind Separation of Co-frequency Modulated Signals Tu Shi-long Chen Yue-xin Zheng Hui (Southwest Electronics and Telecommunication Technology Research Institute, Chengdu 610041, China) Abstract: A basic model is established for mixtures of two co-frequency modulated signals with error-control codes, then an M-PSP based algorithm is proposed to exploit the error-control codes in its single-channel blind separation, with special emphasis on the construction of state trellis, the evaluation of branch metric and the tracking of channel responses. Simulation results show that the proposed algorithm is superior to the algorithms which bypass the error-control codes. For BPSK signals with rate-1/2 convolutional codes, a gain of about 2 dB in signal-noise −4 ratio can be obtained at a bit error rate of 10 . Key words: Signal processing; Blind separation; Single-channel; Error-control codes; M-PSP (Per-Survivor Processing) 1 引言 不同的通信信号已经有了大量的研究并产生了一些 [1] 有针对性的算法。比如针对不同功率混合信号的两 过去十多年来，信号盲分离 已经引起了信号处 理领域一大批研究者的广泛关注。盲分离要解决的