EN62115与EN50088相比的主要不同之处：.docVIP

The requirements in EN 62115 and that of EN 50088 are very similar . The following are the main differences found in EN 62115 When compared with EN 50088: Clause Requirements EN50088 EN62115 5.12 Condition for test The tests are carried out under the unfavourable voltage Also mention about the frequency for ac supply toys. 5.15 Precondition test Following subclause 8.4.2.1 of EN 71－1 The tension force being 70 N independent of the dimensions and applicable independent of age group 6.2 Criteria for reduced testing Additional requirement:For battery compartments including button cell batteries. 17.1 is always applicable. 7.4 Marking and Instruction Only batteries of the same or equivalent type as recommended are to be used. Statement deleted 9.4 short－circuit test 0.5mm steel wire test remained the same .a new 1 mm Rod has also been used to insert through holes in the enclosure up to a depth of 100mm 9.8 Unreliable component short circuit test PTC－S thermistors are short－circuited unless they comply with IEC 60738－1 9.9 Glass or porcelain (other accessible parts) －50K 18 Clearances and Creepage distances Clearances and creepage distances of different polarity of PCB shall not less than 0.2mm if protected against the deposition of dirt. Clearances and creepage distances of function insulation shall not be less than 0.5mm. 19.2.1 Resistance to heat and fire Separately moulded samples of the relevant parts are subjected to the burning test of Annex E or the glow－wire test of EN 60695－2－11 is carried out at a temperature of 550 on corresponding parts of the toy.` Parts of non－metallic material are subjected to the glow－wire test of IEC60695－2－11,Which is carried out at 550℃ .The glow wire test is not carried out on parts of material classified at least HB40 according to IEC60695－11－10,Provided that the tests. 19.2.2 Resistance to heat and fire The glow－wire test is not carried out on parts of material class