电缆导管施工方案精要.doc

电缆导管施工方案 电缆导管安装工艺做法 工程线缆标识 电气安装质量控制点及控制措施 Quality Control Point and Control Measure on Electric Installation Control Point and Control Measure on Electric Installation 分项工程 Sub-item 质量控制点 Quality Control Point 质量控制措施 Quality Control Measure 备注 Remar k 施 工 准 备 Construction Preparation 材料计划、材料送审、施工方案 Material plan, material review and approval, and construction program 认真编制 Work out carefully 明管安装 Open-pipe installation 位置、标高正确、接地良好 The position and elevation are correct, and the grounding is good 绘制综合图及管路接地大样图 Draw integrated drawing and detail of pipeline grounding 桥架线槽安装 Installation on 标高准确、吊架安装、穿墙、楼 绘制综合图、吊架安装图、防火 板的防火处理、与其它专业管道 处理大样图 的间距 Correct level, installation on Draw integrated drawing, installation drawing of hanger crane span hanger frame, fire protection frame, and detail of fire structure slot treatment of through-wall and protection treatment floor, clearance with other special pipeline 穿线配线 Threading distribution 接线正误、导线涮锡、导线损伤 严格执行接线图、涮锡 Wiring correct error, conducting wire with rinsing tin, conducting wire with damage 穿线时注意保护导线 Strictly carry out wiring drawing, rinsing tin, pay attention to protecting the wire when threading 电缆敷设 Cable lay 电缆平直、国定牢国、电缆弯扁 落实图纸、规范相关要求 度、标识 Straight cable, firm fixing, cable bending, and Implement requirements relating to drawing and specification identification 焊接点 Soldered dot 焊接部位的接地电阻、焊点表面 焊接完成后测试焊接部位的接地 光滑饱满 Ground resistance at welded position, and the surface at 电阻 Test the ground resistance of welded position after finishing welded point is smooth and full the welding. 器具安装 Appliance installation 位置正确、安装牢国、观感良好 按绘制的机电综合图、表面器具 The position is correct and installed firmly, the appearance is good. 布置平面图安装 Arrange the plan installation according to electromechanical drawn integration diagram and surface appliance 调试 Debugging 系统运行的稳定性、运行的可靠 制订专项调试方案 性、绝缘摇测 Operating stability, reliability,