Xcalibr 2.0 for DSQ II 的使用教程.docVIP

Installation InstructionsXcalibur Version 2.0.7DSQ? DSQ? IIVersion 2.0.1December 2007IntroductionThis document contains instructions for installing Xcalibur 2.0.7 for the DSQ and DSQ II mass spectrometers plus all gas chromatographs and autosamplers. More information is provided in separate documents on this CD, including \DSQ\Readme.doc.Minimum Requirements2 GHz processor with 512 MB RAM (1 GB recommended for large raw file data collection and processing)CD-ROM driveVideo card and monitor capable of 1280 x 1024 resolution75 GB hard drive (NTFS)Windows XP Professional with Service Pack 2 – US English version onlyMicrosoft .NET Framework version 2.0 must already have been installed even if a later .NET Framework version is installedMicrosoft Office XP Professional SP2 or Microsoft Office 2003 (Word and Excel) – US English version onlyA dedicated 10baseT Ethernet portTRACE GC Firmware version 4.13 or higher and DPFC ROM version 2.00 or higher. Check these by pressing Info|Diag twice to access diagnostics. Then choose Software Info. Instructions are given below for upgrading the firmware.Focus GC Firmware version 2.14 or higher. The current version is shown in the title bar of the virtual keypad. Instructions are given below for upgrading the firmware.The LatestPeriodically check our website, HYPERLINK HYPERLINK , for the latest information. You will find application notes, new manuals, software and firmware updates, and information on new features.Installing the SoftwareComplete the following steps to install Xcalibur version 2.0 on a new computer:Follow the manufacturer’s instructions for upgrading to Microsoft Windows XP Professional with Service Pack 2 or later and Microsoft Office XP Professional SP2 or Microsoft Office 2003 (Word and Excel minimum).Install and configure your Ethernet card.You should do this before installing service packs. If you do this step afterwards, you should re-install the service pack. See instructions below for configuring TCP/IP.