生物制药废水.docVIP

某生物制药厂污水处理站的设计 摘 要 本设计是处理量为3400 m3/d的生物制药废水工艺设计。制药废水的有机物浓度高，成分复杂，含有石油类、胺类、酸类、破乳剂等污染物。此外，水中还含有难以降解的大分子苯环物质和浓度很高的SO42-，水质为CODcr4000~5000 mg/L，BOD5为2500~3000 mg/L，SS 为2000~2500 mg/L，pH值为8~10。利用UASB与SBR组合工艺的处理可以达到去除该废水中有机物的目的。本生物制药废水处理设计流程为：废水经过格栅去除浮渣，出水收集到集水井，再用泵提升至澄清池，澄清池的出水经泵提升进入UASB反应器进行厌氧处理，再经竖配水井，将泥水分离后的上清液进入SBR反应器，在SBR反应器中进行好氧处理。本设计的建设投资为1141万元，处理成本为1.82元/m3。经该工艺处理后的出水水质为CODcr 85 mg/L，BOD5 90 mg/L，SS 68 mg/L，pH 值6~9，达到国家《污水综合排放标准》（GB8978-1996）生物制药废水排放的二级标准。 关键词： UASB+SBR工艺；生物制药污水；活性污泥处理 A biological pharmaceutical factory sewage treatment plant design Abstract Pharmaceutical wastewater of high concentration organic matter, complicated composition, contain oil, amine ，acids, and pollutants such as demulsifier. In addition, the water also contain hard to degrade macromolecular material and high concentrations of benzene ring of water quality, SO42- for CODcr 4000 ~ 5000 mg/L, BOD5 for 2500 to 3000 mg/L, SS for 2000 to 2500 mg/L, pH value for 8 to 10. With UASB and combination of SBR process to remove the wastewater treatment can achieve the purpose of organic matter. The biological pharmaceutical wastewater treatment process design for: wastewater after removing scum, collect water grille to collect, then use to pump water Wells up to clarify the pool, the pool of water pump clear the ascension into the UASB reactor on anaerobic treatment, then through shaft with Wells, will spate separation of after qing liquid into the reactor, the reactor in SBR of aerobic treating. The design of the construction investment is 11.41 million yuan, processing cost is 1.82 yuan/m3. After the treatment technology of effluent water for CODcr after 85 mg/L, BOD5 90 mg/L, SS 68 mg/LpH v, alue of 6 ~ 9, the sewage to the national comprehensive discharge standard (GB8978-1996) biological pharmaceutical waste water discharge of the secondary standard. Key words： UASB+SBR process；Biological pharmacy sewage；activated sludge 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295765436 摘 要 PAG