基于冗余误差控制非均匀有理B样条曲线插补算法研究_徐宏.pdfVIP

DOI ：10.13196/j.cims.2007.05.131.xuh.021 13 5 计算机集成制造系统 Vol. 13 No.5 2 0 0 7 5 Computer Integrated Manufacturing Systems May 2 0 0 7 : 100 - 5911( 2007) 05 - 09 1 - 0 B 1 1, 2 2 1 1 , , , , ( 1. , 411105; 2. , 411105) : B , , , ; , , : B ; ; ; ; : TP391 :A Interpolation algorithm forNURBScurvebased on redundancy error 1 1, 2 2 1 1 X U Hong , H U Z i-h ua , ZH A N G P ing , YA NG D ong-x iang , YA NG D uan-g uang ( 1. Sch. of Mech. Eng . , Xiangtan Univ . , Xiangtan 411105, China; 2. Inst. of Fundamental Mechanics Material Eng . , Xiangtan University, Xiangtan 4 11105, China) Abstract: An interpolation algorithm for Non Uniform Rational B-Spline ( NURBS) curve to control redundancy er- ror was proposed. This method combined advantages of equal chord-error interpolation algorithm and constant fee- drate interpolation algorithm. And a feedrate factor was introduced to improve the error redundancy w hen the in- stantaneous curvature was too small. Also, it could control the chord-error w ithin the specified range w hen the in- stantaneous curvature was too big . Thus, not only the contour accuracy w as guaranteed, but also the machining ef- ficiency was increased greatly. Finally , simulation results demonstrated the effectiveness and feasibility of the pro- posed approach. Key ords: non uniform rational B-spline; interpolation algorithm; chord-error; error redundancy; curvature