斜齿圆柱齿接触线长度计算.docVIP

摘要 齿轮是机械产品的重要零件，齿轮传动是传递机械动力和运动的一种主要形式。它与皮带、摩擦、液压等机械传动相比较，具有功率范围大、传动效率高、传动比准确、使用寿命长、安全可靠等特点。因此，它已成为许多机械产品中不可缺少的传动部件。齿轮设计与制造的水平直接影响到产品的性能和品质。由于它在工业发展中的突出位，齿轮的质量和可靠性已成为机械工业化的一种象征。齿轮传动在航空产品上也得到了广泛的应用，是航空产品，尤其是航空发动机的重要传动件，其性能的优劣在一定程度上决定着整个产品的质量水平。齿轮是机械传动中常用的零件之一, 尤其渐开线齿轮应用广泛。 本文给出了渐开线根切变位圆柱斜齿轮的端面重合度计算公式，推出它的接触线长度的精确计算公式，并首次采用动态统计规律下接触线平均长度作为计算的平均值，使齿轮传动的设计和校核更加精确合理。 利用MATLAB软件，绘制出了接触线长度变化率随端面重合度、纵向重合度的二维和三维图，并分析出重合度的最佳和最差组合条件。同时，给出了接触线长度计算的程序化和参数的动态调整，从而为齿轮的传动设计提供了理论依据和简捷算法。 关键词：斜齿圆柱齿轮 接触线 MATLAB Abstract Gear is an important part of mechanical products, mechanical power transmission gear transmission is a major form and movement.It is with the belt, friction, hydraulic mechanical transmission, compared with a power range, high transmission efficiency, transmission ratio accuracy, long life, safe and reliable.so,It has become indispensable in many machinery drive components.The level of gear design and manufacture a direct impact on product performance and quality.Because of its prominent position in industrial development, quality and reliability of the gear has become a symbol of industrial machinery.Gear products in the air has also been widely used in aviation products, especially the importance of aero-engine transmission parts, its performance advantages and disadvantages to some extent determines the quality of the product.Commonly used in mechanical transmission gear is one of the parts, in particular, are widely used involute gear. In this paper, undercut involute helical deflection face contact ratio gear formula,Launched its exact length of the contact line of the formula,Statistical law for the first time under the dynamic contact line as the calculation of the average length of the average, the gear drive design and verification more accurate and reasonable. Using MATLAB software, to map out the rate of change of contact length with the face contact ratio, degree of vertical two-dimensional and three-dimensional coincidence map, and analyze the deg