金属线槽配线安装工艺流程.docVIP

金属线槽配线安装工艺流程 金属线槽配线安装工艺流程提要：保护地线应根据设计图纸要求敷设在线槽内的一侧，接地处螺丝直径不应小于6mm，并且需要加平垫和弹垫，用螺母压接牢固 金属线槽配线安装工艺流程 （1）弹线定位： 根据设计图纸的要求，用粉线袋沿墙壁、顶棚或地面，弹出线槽的走向位置。 （2）支架与吊架安装： 支架与吊架所用钢材应平直。无显著扭曲。 支架与吊架应安装固定，保证横平竖直，固定点间距不应大于~2m。 在进出接线盒、箱、柜、转角、转弯处应设置固定支持点。 支架与吊架距离上层楼板不应小于150-200mm,距地面高度不应低于100~150mm。 （3）保护地线安装： 保护地线应根据设计图纸要求敷设在线槽内的一侧，接地处螺丝直径不应小于6mm，并且需要加平垫和弹垫，用螺母压接牢固。 金属镀锌线槽之间，可使用连接板连接，每端螺丝固定点不少于4个。 （4）线槽内配线： 线槽内配线前应清除线槽内的积水及污物。 在同一线槽内的导线截面积总和应该不超内部截面积的40%。 线槽口向下配线时，应将分支导线分别用尼龙绑扎带绑扎成束，并固定再线槽底板上，以防导线下坠。 （5）线路检查及绝缘摇测： 线路敷设接线完成后应用摇表摇测，线路的绝缘摇测一般选用500V摇表，低压电缆使用1000V摇表。摇测时一人摇测，一人应及时读数并记录，摇动速度应保持在120r/min，读数应采用1min后的读数。 daily morning exercises or class-break setting-up exercise and discipline inspection and appraisal of public signs;2, daily cleaning and inspection;3, the daily student school appearance, dress, wearing school card check;4, the daily duty guide to the leadership class discipline three rounds.Weekly moral education work:L, the flag raising ceremony and the national flag speech under the flag raising ceremony held on Monday;2, every week a class meeting, the meeting;3, every week two exercises, cleaning and hygiene, behavior norms, attendance situation published cloth appraisal, and the issue of the code of conduct;;4, weekly work week.Monthly moral education work:1, at least once a month, the theme of education activities, to patriotism education, behavior norms of education as the focus, combined with major retreat day.2, the monthly class quantization assessment and class teacher assessment, selection of behavior for the standard model class.Moral education in each term:1, at the end of each semester to form three good student, outstanding student cadres, civilized student.2, at least once a semester, parents will be.,Student etiquette conventionA, the school leavers1, dress neatly to wear school card, step posture correct, full of spirit; cycling of the same students, at the school gate and get off, go to t