焊接元器件及工具介绍.doc

整理了一些资料来帮助大一的学弟学妹进一步认识，了解一些常用的焊接工具并简单介绍了一些常用的元器件（附有图片）以及焊接过程中的注意事项。 焊接电路图： 极性电容：长的引脚为正极，短的引脚为负极。该电容大小为220uf。（如下图） 非极性电容：不区分正负极，上面104代表了电容大小为10x10^4pf=100000pf=100nf=0.1uf。（如下图） L7805稳压芯片：该芯片为5v稳压芯片，正面从左往右数分别对面引脚1，2，3. 1引脚接输入电压，2引脚接地，3引脚为大小是5v的输出电压端（如下图） 正面： 反面： 电烙铁 正确使用电烙铁 1、电烙铁使用前要上锡，具体方法是：将电烙铁烧热，待刚刚能熔化焊锡时，涂上助焊剂(松香)，再用焊锡均匀地涂在烙铁头上，使烙铁头均匀的吃上一层锡(亮亮的薄薄的就可以)。 2、在进行普通焊接的时候(比如在万能板上焊接直插式元件)，一手烙铁，一手焊锡丝，靠近根部，两头轻轻一碰，一个焊点就形成了。 3、在万能板上焊接直插元件时，要将引脚尽量插到底。 4、焊接时间不宜过长，否则容易烫坏元件，必要时可用镊子夹住管脚帮助散热。 5、焊接完成后，。 可以非常牢靠地和针连接，无需焊接剥除线头部的表面绝缘层 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or