DC充电插头充电插头产品详解.PDFVIP

DC 充电充电插头插头产品产品规格书规格书 108-137188 充电充电插头插头产品产品规格书规格书 DC EV Charge product specification 25 Aug.2016 Rev A 1.0 SCOPE 范围范围 范围范围 1.1. CONTENT 内容内容 内容内容 This specification covers product performance, test methods and quality requirements for DC EV charge gun, Applicable product descriptions and part numbers are as shown on product drawing. 本规格书规定了直流产品性能，测试方法及质量要求，适用的产品料号及产品描述详见产品图面。 1.2. Qualification 检测检测: 检测检测 When tests are performed on the subject product line, procedures specified shall be used. All inspections shall be performed using the applicable inspection plan and product drawing. 当在产品线进行测试时，应按照指定的程序操作。所有的检验均应按照适用的检验计划和产品图纸来进行。 2.0 APPLICABLE DOCUMENTS 适用适用文件文件 适用适用文件文件 The following documents form a part of this specification to the extent specified herein. Unless otherwise specified, the latest edition of the document applies. In the event of conflict between the requirements of this specification and the product drawing, the product drawing shall take precedence. In the event of conflict between the requirements of this specification and the referenced documents, this specification shall take precedence. 除非特别说明，本份文件所涉及的文档均应按照最新版本执行。当本份规格书要求和产品图纸有冲突时， 应以产品图纸为准。当本份规格书要求和参考文件有冲突时，应以本规格书为准。 2.1 TE Connectivity Documents: TE 文件文件 文件文件 501-137188: C-2271798: 3.0 REQUIREMENTS 要求要求 要求要求 3.1 Design and Construction 设计设计及结构及结构 设计设计及结构及结构 Product shall be of the design, construction and physical dimensions specified on the applicable product drawing. 产品应满足产品图纸上规定的设计、结构和物理尺寸要求。