网络摄像头说明书解析.docxVIP

Table of ContentsIntroduction1Power Supply to the IP Camera1iOS Mode (for iPhone / iPad)2First Time Settings or Changing to a New Wi-Fi Router2Adding Second iOS Device to Existing IP Camera Connection61. Under Wi-Fi environment which has completed first time settings62. Outside of Wi-Fi environment which has been set9Introduction of App Interface101. Live Monitoring Page102. Settings Page113. Basic Setting114. Advanced Settings12Android Mode (for Android O/S Devices)13First Time Settings or Changing to a New Wi-Fi Router13Adding Second Android Device to Existing IP Camera Connection171. Under Wi-Fi environment which has completed first time settings172. Outside of Wi-Fi environment which has been set21Introduction of App Interface221. Live Monitoring Page222. Setting Page23Specifications25SpeakerIntroductionLED IndicatorNight Vision LEDsUSB PortResetmicroSDCard SlotMicrophoneLensPower Supply to the IP Camera1.Connect the USB cable between USB port and the included AC adaptor.2.Connect the AC adaptor to the power source.iOS Mode (for iPhone / iPad)NOTE: The O/S version of the iPhone or iPad must be iOS5.0 or later.First Time Settings or Changing to a New Wi-Fi RouterSTEP 1After the IP camera is connected to the power source, please wait for approx. one minute until the blue LED indicator starts flashing. If the blue LED indicator is not flashing, the IP camera will need to be reset. Please use a pin to stick into the RESET hole on the back side of the IP camera and hold for around 10seconds and then release. The IP camera will restart.STEP 2Install the App named “GuardPro” from App Store.NOTE: If you have purchased this IP camera bundled with JAY-tech Tablet PC series, this App may have already been pre-installed and the App’s name is “GuardPro”. Thus you can skip this step.STEP 3Go to “Settings” of the Apple Device and select “MyAPxxxx” from the available Wi-Fi AP list.After the Apple Device is successfully connected to that Wi-Fi AP, will appear.STEP 4Enter the Ap